Laurel-electronics LAUREATE SERIES 2 COUNTER-TIMER-SERIAL INPUT METER Manual de usuario descargar pdf (Pagina 37)

Press

Press Digit

Select Key

Press Value Select

Key

Coordinates of 2 points scaling method if selected under SEtuP

.Lo_In1.

Low signal

input 1.

000000 000000 000000

Select digit to flash.

Select -9 thru 9 for flashing first digit and 0 thru 9

for other flashing digits. Move decimal point location

when flashing.

Lo_ rd1

Reading at

Lo In1.

000000 000000 000000

Select digit to flash.

Select -9 thru 9 for flashing first digit and 0 thru 9

for other flashing digits. Decimal point is fixed by

dEC.Pt1.

.Hi_In2.

High signal

input 2.

000000 000000 000000

Select digit to flash.

Select -9 thru 9 for flashing first digit and 0 thru 9

for other flashing digits. Move decimal point location

when flashing.

.Hi_rd2.

Reading at

Hi In2.

000000 000000 000000

Select digit to flash.

Select -9 thru 9 for flashing first digit and 0 thru 9

for other flashing digits. Decimal point is fixed by

dEC.Pt1.

Special curve offset for square root or custom curve linearization if selected under ConFiG

.rd0_In.

000000 000000 000000

Select digit to flash.

Select -9 thru 9 for flashing first digit and 0 thru 9

for other flashing digits. Decimal point is fixed by

dEC.Pt1. Enter 04.000 for square root extraction

with a 4-20 mA signal.

Scale multiplier

rESoLn.

Resolution

Flashing 6-digit number

in decade steps from

0.00001 to 100000

Press to select. This multiplier R appears with the

Batch mode and can be applied to Grand Total to

set its decimal point.

Quartz crystal time base calibration

_CALib Time base calibration. Do not change. See Calibration section of manual.

Option dependent menu items

SourcE AL SEt. AL S34 dEUn1H dEUn2H dEUn1b dEUn2b dEUn3H DEUn4H DEUn3b

DEUn4b Menu items related to alarm setup These will only appear if a relay board is

detected. If so, please see Section 14.

An_SEt An_Lo An_Hi or An_SEt An_Lo1 An_Hi1 An_Lo2 An_Hi2 Menu items

related to analog output. These will only appear if a single or dual analog output board is

detected. If so, please see Section 15.

_SEr_1 _SEr_2 _SEr_3 _SEr_4 Menu items related to serial communications. These will

only appear if an RS232 or RS485 I/O board is detected. If so, please see Section 16.

Menu lockout items

_Loc_1 _Loc_2 _Loc_3 _Loc_4 Menu items used to enable or lock out (hide) other menu

items. Loc menu items may be locked out by a hardware jumper. Please see Section 9.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Comentarios a estos manuales

Sin comentarios

Laurel-electronics LAUREATE SERIES 2 COUNTER-TIMER-SERIAL INPUT METER Manual de usuario Pagina 37

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Laurel-electronics LAUREATE SERIES 2 COUNTER-TIMER-SERIAL INPUT METER